SSS - Sigillante spruzzabile - 290ml

SSS 100-400

Key features

• MS Polymer

• Firm-setting sealer for interior and exterior auto body seams and joints.

• Replaces and repairs factory sealing jobs in trunk, floor and drip rail areas.

• No primer needed, good adhesion, lasting flexibility.

• Atomised, by using a combi sealant gun (CSG 00), the seam sealer can be used inside door skins, inside body panels, or any area where a sound deadening and/or structured coating is needed.

• Standard 290ml cartridge, fits in all standard caulking guns.

• Available in white, grey, black and beige colour.

• Paintable after 30 minutes with any primer, water- or solvent-based basecoat or topcoat.

Dust Extraction Advice

Dettagli del prodotto

Number: SSS 100-400
Application surfaces: steel E-coating galvanized steel aluminum fiberglass hard plastic soft plastic chrome rubber new paint good paint neglected paint matt paint gelcoat putty primer/filler OEM paint refinish paint wood zinc enamel ceramic copper lead stainless steel high-pressure laminate stone concrete gypsum board cement fiber panels polyethylene polypropylene polycarbonate polymethyl methacrylate
Base ingredient(s): MS polymer
Corrosive to metals: no
Free of isocyanates: yes
Free of silicones: yes
Length: 5 cm
Maximum processing temperature: 40 °C
Maximum temperature resistance: 90 °C
Minimum processing temperature: 5 °C
Minimum temperature resistance: -40 °C
Paintable: yes
Resistances: UV
Type: cartridge
Volume: 290 ml
Colore: bianco
Freezing resistant: sì
Maximum storing temperature: 90 °C
Storing condition: dark
Weight: 1

Application

SSS 100-200-300-400 application - Directions for Use

Surface Preparation: Ensure all surfaces are clean, dry, and free of grease or dust.
Cartridge Loading: Insert the cartridge into a compatible spray gun.
Test Spray: Perform a test spray on a scrap surface to ensure proper flow and pattern.
Application: Spray the seam sealer evenly along the seam, joint, or surface to be sealed or use a (pneumatic) applicator gun to spray the sealer onto the surface.
Cure Time: Allow 24 hours for a layer thickness of 2-3mm to fully cure.

HIGH QUALITY

Our products are tested extensively before they are brought onto the market.

ECOLOGICAL

We work on finding solutions to replace traditional solvent-based products by high-performing water-based alternatives.

INNOVATION

Our research and development department focuses on product innovation and improvement in order to not only meet the demands of the market, but to simplify the car repair process.