TSP - Wheel spray silver 400ml
TSP 520
Revitalize your alloy wheels with our Silvery Grey Wheel Spray. Ensures fast and easy repairs for most alloy wheels on the market. The quick-drying paint, enriched with real metallic particles, guarantees a superior finish that is both UV-resistant and suitable for internal and external use. Per can.
Key features
-
- • Light and ultrafine silvery grey TSP 520 for alloy repair.
-
- • Fast and easy repair for most alloy wheels on the market.
-
- • Quick-drying paint with real metallic particles.
-
- • Superior paint finish.
-
- • Suitable for both internal and external use.
-
- • Easy to use and time-saving.
-
- • UV resistant.
Product details
- Brand
- Finixa
- Number
- TSP 520
- Colour
- silver
- Dry storage
- yes
- Storing condition
- dark
- Freezing resistant
- yes
- Units for outer box
- 12
- Units for pallet
- 672
- 1K product
- yes
- 2K product
- no
- Application surfaces
- steel; aluminum
- Base ingredient(s)
- solvent
- Flash point
- 4 °C
- Lead-free
- yes
- Maximum air humidity
- 80 %
- Minimum processing temperature
- 10 °C
- Paint type
- solvent-based
- Paintable
- no
- Propellant
- butane; propane; isobutane; dimethyl ether; nitrogen
- Recommended curing temperature - IR
- 20 °C
- Recommended number of layers
- 2-3
- Resistances
- UV; weather
- Type
- aerosol
- VOC
- 800 g/L
- Volume
- 0.4 L
- Workable surface state
- dry
Application
-
TSP 520 application - Directions for use
- Preparation: Remove the wheel and clean it thoroughly to remove any dirt, grease, or previous coatings.
- Sanding: Lightly sand the surface for better adhesion.
- Masking: Mask off the tire and any areas you do not wish to paint.
- Shake Well: Shake the can vigorously for at least 2 minutes after the mixing ball starts rattling.
- Test Spray: Apply a small amount to a hidden area to check compatibility and finish.
- Application: Hold the can 20cm – 30cm (8-12 inches) from the surface and apply 2-3 even coats, allowing 10-15 minutes of drying time between each coat.
- Curing: Allow at least 24 hours for the paint to fully cure before reinstalling the wheels.
- Clean Nozzle: Invert the can and spray for 2-3 seconds to clear the nozzle.