CBP 10 - Spray booth protect pro 10l
CBP 10
Protect your spray booth walls with this transparent, tacky, and washable coating
It traps dust, applies easily in a single layer, and removes with water. Biodegradable and long-lasting, it shields for 10-12 weeks per 12 liters, varying by temperature and humidity. Reapply as needed. Per can.
Spray booth protect basicis a waterbased dispersion that complies with environmental norms, security & health standards. This product is stabilized with a system of biodegradable surface active substances and contains no plasticizers.
The product is only used on hardened undergrounds as sticky coating. Specific application on walls of spraybooths existing in aluminium/inox, galvanised and varnished walls.
Key features
- Transparant, tacky and washable coating for the protection of spraybooth walls against overspray. Product stays tacky in order to hold on to swirling dust
- Apply one thick layer by means of a pressure tank, airmix in 1 thick layer
- Remove afterwards with water and sponge
- Biodegradable
- Remove or apply another coat when the product is no longer tacky
- Average consumption per spraybooth: 12L
- Depending on temperature and humidity, the product will stay tacky for 10-12 weeks
- Number of layers (min-max): 1/3
- Coverage: 10m²/L/layer
- Can be applied over 2 dried layers of powerpeel for easy removal
Product details
- Brand
- Finixa
- Number
- CBP 10
- EAN
- 5491196001172
- Colour
- Transparent
- Volume
- 10 L
- Shelf life
- 24 months
- Storage conditions
- Avoid high fluctuation in temperature
- Freezing resistant
- no
- Units for pallet
- 60
- Application areas
- walls
- Film
- transparent, sticky
- Heat resistance
- 67 C°
- PH-value
- +/- 8-9
- Removal
- washable
- Return
- 15 to 20m² / liter/layer
- Specific weight (g/L)
- 1,05 g / cm³
- Tacky
- yes
- Viscosity
- standard 900-1000 cps with SP5 / 100T/min Brookfield RVT
Application
-
CBP applicationDirections for use with pressure tank:
- Use a pressure tank like our SPG 80, with a nozzle 2.0-2.5mm. pressure in the tank should be at 2.0-2.5 bar.
- Do NOT dilute the product.
- Apply in 1 closed layer.
- When product starts drying out, apply an additional coat. Coats can be built up to a total of 3.
- Clean using hot water and sponge, with addition of a drop of liquid soap, or pressure sprayer.
- Apply a thin smooth layer, to prevent product from dripping / sagging.
- Do NOT dilute the product.
- Re-apply after product loses stickiness.