SFDE 2000 - Finishing film discs Ø150mm-15 holes P2000 50p.

SFDE 2000

Key features

• Premium film abrasive for matting and paint correction

• Aluminium oxide grain, Polyester film backing

• Very fine scratch pattern for fast and easy polishing

• Ultra-flat and smooth film backing

• Specially developed stearate layer for les clogging and longer lifespan

• Intended for dry sanding only

• For best results use on a 3 mm deviation DA sander with a 5mm interface pad (SAM 37)

Dust Extraction Advice

Product details

Brand: Finixa
Number: SFDE 2000
Colour: white
Material: film
Dry storage: yes
Storing condition: dark
Freezing resistant: yes
Units for outer box: 10
Applicable for: orange peel removal dust nib removal paint runner removal removing micro scratches removing deep scratches matting blending
Application surfaces: steel E-coating galvanized steel aluminum aluminium RIMS fiberglass hard plastic soft plastic chrome rubber new paint good paint neglected paint matt paint gelcoat putty primer/filler OEM paint refinish paint wood zinc enamel ceramic copper lead stainless steel high-pressure laminate stone concrete gypsum board cement fiber panels polyethylene polypropylene polycarbonate polymethyl methacrylate polytetrafluoroethylene chlorides thermosetting composites carbon fiber thermoplastics coated metals
Attachment type: hook and loop
Carrier: film
Coating: semi-open
Diameter: 150 mm
Grit size: 2000
Grit type: aluminium oxide
Length: 150 mm
Number of holes: 15
Perforated: yes
Thickness: 1 mm
Type: box
Use: dry
Use by hand: no
Use with machine type: eccentric
Width: 150 mm

Application

SFDE – SFDF application

Directions for use
Intended to be used on a excentric rotating sander. For best results use on a 3mm deviation sander with a 5mm interface pad. The discs can only be used for dry sanding. Product especially suited for preparation before blending in grits P800 & P1000, and for paint defect rectification in grit P1500, P2000, and P2500.

Start the sander ON the surface and stop OFF the surface. This will significantly reduce swirl marks.
Apply light hand pressure on the sander and allow the backing pad to move freely. Let the tool do the work.
Run the sander flat on the surface to prevent gouging.
Follow a set pattern when sanding. This ensures that previous scratches are removed and a uniform finish is reached. Always follow the sanding steps prescribed by your paint supplier.

HIGH QUALITY

Our products are tested extensively before they are brought onto the market.

ECOLOGICAL

We work on finding solutions to replace traditional solvent-based products by high-performing water-based alternatives.

INNOVATION

Our research and development department focuses on product innovation and improvement in order to not only meet the demands of the market, but to simplify the car repair process.